The 1/4 in. hex torque drive has been calibrated for +/- 6% accuracy. It’s positive bit locking to eliminate slippage or dropping in tight spaces. Perfect for technicians working on aluminum to copper connectors requiring limited torque.
- Certified torque range of 8-40 in.-lbs.
- Torque accuracy of +/- 6% CW in the upper 80% of tool capability (between 8-40 in-lbs.)
- Works with 1/4 in. bits
- Not insulated
- Ergonomic grip
- Hard plastic case for storage and protection
- Meets or exceeds ANSI standards
- Call 1-888-HD-HUSKY for customer service and support.
Javonte Senger (verified owner) –
Easy to use. Just what I needed for less than 10 ft*lb applications.
Daisy Rice (verified owner) –
Worked for what I needed it to.
Ludie Gottlieb (verified owner) –
good tool accurate
Willie Ziemann (verified owner) –
Would give this torque driver 5 stars, but I’ve only had it about a month and have only been able to use it once, so far. Feels like a quality tool and torques specs were accurate. Never owned a Husky tool, before… but it certainly looks an feel professional grade. Awesome protective case.
Ozella Wyman (verified owner) –
Works great!
Ron Rowe (verified owner) –
Easy to adjust after a couple of uses.
Ola Crooks (verified owner) –
Works great for what I needed
Anthony Klocko (verified owner) –
Used this to torque scope rings and base mounts. Easy to setup. Readily accepted quarter inch bits and held them in place without problems. Positive stop when desired torque settings achieved. Has the feel of a quality tool
Eleonore Casper (verified owner) –
The torque screwdriver worked perfectly!
Wilhelm Robel (verified owner) –
Driver feels solid and works well. It does come with a certificate of certification to be within 6% of the weight setting.
Ethyl Marvin (verified owner) –
The torque screwdriver did exactly what I needed. We needed to measure the torque used on screws to hold a plastic assembly together to determine what range the required torque fell into. With the data gathered from this inexpensive tool, we purchased a production line tool to speed assembly. Setting the torque on this very expensive tool to what was indicated by the torque screwdriver produced the results we were looking for without any changes. This is a great inexpensive tool that does exactly what it is intended to do.
Rosanna Beier (verified owner) –
Worked as advertised!
Hoyt Marks (verified owner) –
Worked great for installing aluminum wire compatible outlets
Marjory Ondricka (verified owner) –
Excellent for firearm use. For use on scopes, rails, takedown screws and grips. It would have been nice to have been supplied with some basic bits. Otherwise it works as it should and operation is straight forward.
Laney Padberg (verified owner) –
For the price it was worth it. Different Handel on tool would’ve been my improvement
Justina Quigley (verified owner) –
Works great……I hope….LOL Needed it for some gunsmithing. I have now way of testing it’s measurements. And easy to use. Set the torque and then when it hits what you set, it breaks free, or gives out so you don’t put anymore to the item you are tightening. I just go slow while adding torque until it gives. All done.
Jaqueline Runolfsson (verified owner) –
Product worked great for mounting bases and scopes on hunting rifles.
Isabelle Kemmer (verified owner) –
It works for what I wanted for.
Jensen Gaylord (verified owner) –
So far, so good! It was easy to figure out how to set the correct torque. I primarily purchased it to complete an electrical project and it worked great.
Darrin Quitzon (verified owner) –
Met and exceeded the expectations of use. Very easy to change as well.