Milwaukee Laser Temperature Gun Infrared 12:1 Thermometer

14 reviews for Milwaukee Laser Temperature Gun Infrared 12:1 Thermometer

1. Rated 4 out of 5

   Jedidiah Cummings (verified owner) – September 23, 2022

   There were two problems, right off the bat: 1) the blister pack was exceedingly difficult to open, and 2) the battery was very difficult to install. I had to use a razor blade to cut through the plastic to open the package. Even then, it was difficult to remove. The battery cover has a “lock” which needs to be turned with a flat-head screwdriver or coin to open ; even then, I found it difficult to do. Then, I had difficulty removing the 9-volt battery (which came with the device) connector, and then attaching it to the battery, and then fitting it back into the device. However, once that was accomplished, I found the thermometer very easy to use: Pull the trigger, sight along the laser dot, and read the result (n.b., contrary to the manufacturer’s images on Home Depot’s product page you can only see a dot at which the device is aimed, not an extended “line”! Granted, it’s just for reference, but, some folks might think they’ll be able to see it!). I have no scientific equipment to gauge it with, but, it is close to my mercury thermometers’ readings. I tested it for its accuracy from multiple distances (see photo), and the reading was virtually the same from 1, 2, and 3 feet away. I found the device useful for finding hot or cold spots along walls, and it even helped me find a gap in an outer wall of my home, which I was able to fill with insulation and then caulk over! Oddly, its readings for my refrigerator and freezer varied, depending on where it was aimed; I didn’t expect it to be exactly the same throughout, but, I was surprised to find a range of 5 degrees between shelf levels, and between depths on the same shelf, though it confirmed that the refrigerator’s built-in thermometer was accurate! I even used it to find a hole in my car’s exhaust system, by noting that most of the pipe from the catalytic converter to the middle of the system was about the same temperature, but, it dropped, drastically, just before the muffler. It turned out to be a dime-sized hole about a foot away from the muffler, which I was able to wrap with sheet metal and clamps, thus saving me a trip to the muffler shop, and, probably, saving me a bundle of money, as well! I also used it to test the boiling point of a pot of water, which I expected to read 212 degrees F, but, it read 190; I’m not sure what to make of that! (i.e., is it the true temp of the water, or is the device off?) I have a much cheaper ($20), no-contact thermometer gun by a different manufacturer, but it doesn’t have a laser, and it always reads 1-3 degrees less than the Milwaukee gun. Since exact temperatures aren’t important to me, it seems to be a minor point. Also, the software “trigger lock” and “alarm” functions don’t have any real use for me (to tell you the truth, I’m not even sure why a “trigger lock” is needed), so I didn’t bother testing them. It would have been nice if the device had a loop to which I could have attached a tether to my wrist or tool belt, so I wouldn’t have to hold it all the time. In conclusion, this is a very nice device, but, there are cheaper alternatives, and, unless you have a scientifically accurate thermal gauge, accuracy probably isn’t important for most people.

2. Rated 5 out of 5

   Filomena Murazik (verified owner) – September 13, 2022

   Very accurate and easy-to-use

3. Rated 5 out of 5

   Osborne Heller (verified owner) – July 27, 2022

   Simple to use,accurate,easy to read

4. Rated 5 out of 5

   Bertha Dooley (verified owner) – January 24, 2022

   Tis a nice basic unit for entry level interest for around the home items like cold spots on exterior walls, bad light switch or breakers and just plain general temp readings. The fixed emissivity kind of locks you to basic temp readings on basic materials where a wide array of materials and finishes could swing readings to be inaccurate due to specific emissivity ratings. There is some research to invest some time in educating yourself about emissivity ratings to get a better understanding what IR thermometer is best for you. It is likely that if you already you need one with adjustable emissivity, you are in a field where you fully understand it and require it to be more accurate. I have a very expensive unit that is fully adjustable with liquid probes and such for specific uses where this one will be in the basic homeowner toolbox in the garage so my nice unit does not get damaged. Again, this is a good unit for the basic “around the house” checking for your own insurance of where you might need to add insulation and such and good for temp swings and not so much for half a degree accuracy based on fixed emissivity.

5. Rated 5 out of 5

   Maximillian O’Reilly (verified owner) – November 16, 2021

   This Laser Temperature gun is very usefull, I like this produce because seve the last temperature that you took.

6. Rated 4 out of 5

   Marlene Rice (verified owner) – October 27, 2021

   Tough products good quality I tried in my freezer I tried in high temperatures The accuracy of temp looks good i tried the temp my self 98.7

7. Rated 5 out of 5

   Randall VonRueden (verified owner) – October 18, 2021

   This tool is easy to use – there is a door on the front of the handle that you have to open and hook up the 9V battery (provided). Turn it on aim & pull the trigger. You can see the red laser dot in the photo – it measures the surface temperature and the laser is easy to see. The digital readout is easy to read (large LCD numbers) and is consistent with the temperatures I expected to see. The tool is light (but not cheap feeling) and is a nice size for a handheld tool.

8. Rated 4 out of 5

   Kirsten Gleason (verified owner) – August 16, 2021

   This Milwaukee 12:1 infrared temp gun is well built, but is a little lacking on features for what it’s currently priced at. They also sell an NIST version for a higher price, which may be more desirable for a professional that requires a certified instrument.The temp gun is pretty intuitive, and I found that I didn’t even need to consult the manual to get full functionality out of it. The controls and menus are pretty simple, and the backlit display is easy to read, even at vertical angle offsets – although it washes out or oversaturates pretty quickly when you try to read it from an angle at the side.The laser marker can be turned on or off in the settings, and clearly marks the center of the temperature reading. It would have been nice if there were at least two or three laser points that fanned out at the same rate as the sensor effective area. As it is, I just have to remember that for every foot I am away from the target, the diameter of the sensing area increases by an inch.The temperature range is pretty good, from -22°F to 1022°F. I didn’t test it to these extremes, but I did check it with my freezer and stovetop, and managed to give it a workout from 4°F to 669°F. It read a teakettle at 206°F right before it started whistling, so it seems to be pretty accurate too.Emissivity is fixed at 0.95, which poses a problem for accurate readings on shiny surfaces. This can be remedied by placing matte tape on the surface to be measured, but an adjustable emissivity instrument with an auxiliary thermocouple wouldn’t need this additional step.Battery life seems to be pretty good, and replacing the 9V battery in the handle is very easy and only requires a flat head screwdriver. Should take 30 seconds max. I really don’t see a reason to go with the M12 version of this, since it will just add bulk and weight to the handle.Unfortunately the price to feature ratio this temperature gun offers is pretty high. There seem to be a few other highly rated temperature guns out there for less than half the price of this one that offer more features. The build quality of this instrument is great, and Milwaukee has announced its ruggedness as being able to handle a 6 foot drop test. So I’m not sure if the high price is just for the build quality or maybe just the Milwaukee Red color scheme.

9. Rated 5 out of 5

   Tessie Weimann (verified owner) – August 11, 2021

   The Infrared Laser Temperature Gun is very lightweight and durable. This one does not come with the battery; only the Temperature Gun its self. The large LCD screen is very easy to read and very informative. This Temperature Gun is very is great for checking the temperature around windows to see if there are any drafts and the air coming from vents.

10. Rated 5 out of 5

    Felix Willms (verified owner) – April 11, 2021

    Great temp gun, love the hold feature. The trigger is easy to use.Batter life is great.

11. Rated 5 out of 5

    Alaina Wyman (verified owner) – March 24, 2021

    What pushed me over the edge to get this was to channel my inner Alton Brown. For several cooking adventures like frying a turkey, smoking, and/or various cast iron delicacies I was never able to get a solid read on temperature. (other than probe thermometers in some circumstance) The secondary use was to actually use this as intended – checking metal temps for tempering, HVAC work, and other various shop tasks. I can say it’s excelled at both. Works every time, easy to read, and 100x more durable than the cheap-o stuff you might get offline or from places that rhyme with ‘Shmarbor Smreight’. This thing brings out my inner nerd and I love it.

12. Rated 4 out of 5

    Jaunita Mosciski (verified owner) – February 13, 2021

    This Temp Gun is “Good” but I’m not sure it’s priced right.The temp readings are accurate and the gun is very comfortable to hold. It’s relatively small so I can put it in my back pocket (handle down) to carry it around. It also fits neatly and more securely into most tool belts and since it has a reinforced plastic frame and nose bumper it’s durable enough to toss around a bit.The 12:1 ratio is good for most applications (1 foot scan 12 feet away).It comes with and runs on a 9V battery which will not last as long as the lithium-ion models.It has typical features like Hi & Lo temp setting alarms and modes like +/- and Avg temp but it does not store multiple temps like some other guns. Also, it does not have an external temp probe or the option to use one.There are only two things that bother me about this gun. The trigger sticks and “boings” when it lets go and the display is uni-directional. It can only be viewed straight on. The Product Description says its “Premium LCD Display”, I disagree. Note: the product description also states that it can survive 9 foot drops, but the packaging clearly states 6 foot drops.

13. Rated 5 out of 5

    Lacy Waters (verified owner) – January 4, 2021

    works great easy and simply to use I would recommend to anyone

14. Rated 5 out of 5

    Keira Murphy (verified owner) – December 25, 2020

    What pushed me over the edge to get this was to channel my inner Alton Brown. For several cooking adventures like frying a turkey, smoking, and/or various cast iron delicacies I was never able to get a solid read on temperature. (other than probe thermometers in some circumstance) The secondary use was to actually use this as intended – checking metal temps for tempering, HVAC work, and other various shop tasks. I can say it’s excelled at both. Works every time, easy to read, and 100x more durable than the cheap-o stuff you might get offline or from places that rhyme with ‘Shmarbor Smreight’. This thing brings out my inner nerd and I love it.